Four processes of steel bar processing

Release Time :

2024-10-15 11:57

The processing of steel bars generally involves four processes: rust removal of steel bars; Straightening of steel bars; Steel bar cutting; Forming of steel bars.
When the steel bar joint is connected with straight or conical threads, it is also necessary to add the steel bar end upsetting and thread processing procedures. Rebar batching and replacement Rebar replacement
(1) When replacing the steel bars specified in the design documents with steel bars of another steel grade or diameter, the following regulations should be followed:
The principle of equal design values for the bearing capacity of steel bars should be followed, and the replacement of steel bars should meet the specified structural requirements such as steel bar spacing, anchoring length, and minimum steel bar diameter.
When replacing lower grade steel bars with higher grade steel bars, it is advisable to use the method of changing the diameter of the steel bars instead of changing the number of steel bars to reduce the cross-sectional area of the steel bars.
(2) When using a certain diameter steel bar of the same steel grade to replace another diameter steel bar, the diameter variation range should not exceed 4mm. The ratio of the total cross-sectional area of the changed steel bar to the cross-sectional area specified in the design document should not be less than 98% or more than 103%.
(3) When replacing the main reinforcement with steel bars of the same steel grade, the spacing should be kept constant, and two types of steel bars with diameters one level larger and one level smaller than the designed steel bar diameter can be used for replacement.

RELATED NEWS


2026-10-08

ASTM A36 vs. Q235 Steel: Chemical Composition, Properties and Equivalents

This article compares ASTM A36 and Q235 structural steel, covering chemical composition, mechianical properties, common applications, and grade equivalence, while introducing Bao Metal as a supplier for international steel buyers. When sourcing carbon steel plates, you've probalbli come across ASTM A36 and Q235. Both are widely used in construction and manufacturing, but are they actually the same? Understadning their differences can help you choose the right material and avoid costlu purchasing mistakes.

2026-09-17

How Surface Decarburization Can Affect Machined and Heat-Treated Steel Parts

This article explains how surface carbon loss develops during heating and how it can reduce the hardness, wear resistane, fatigue life, and dimensional reliability of finished steel parts. Surface decarburization occurs when carbon near the surface of steel reacts with the furnace atmosphere during heating. The carbon content in this outer layer decreases, leaving it softer than the material underneath.

2026-09-11

How Stainless Steel Surface Finishes 2B, No.1, BA and No.4 Differ

This article explains the differences between common stainless steel finished such as 2B, No.1, BA, and No.4, including their appearance, processing methods, and typical applications. When buyers compare stainless steel sheet or plate, the grade is only part of the specification. The surface finish can also affect appearance, formability, cleaning, downstream polishing, and final use. Finishes such as 2B, No.1, BA, and No.4 are not simply comestic labels. You can think fo them as different surface conditions created by different processing routes, each suited to do a different job.

2026-08-21

How to Calculate Steel Plate Weight from Thickness, Width and Length

This article explains how to calculate the theoretical weight of a steel plate using thickness, width, length, and steel density, while showing buyers why dimensions and tolerances still matter when placing an order. When you buy steel plate, weight is often used to calculate quantity, freight, and total order value. Fortunately, you do not need complicated software to estimate it. If you know the plate thickness, width, and length, you can calculate the theoretical weight with a simple formula. Think of it like calculating the volume of a box and then asking how heavy the material inside that box is.